Discussion
Paul, probably a bit over the top but if you are going to do the job, you might as well do it properly. From my 95 Griff in bits:
Overall stud length is approximately 52mm:
Thread length is approximately 27mm:
Thread is M12 x 1.5
As far as I can see, all the studs are the same and are almost certainly original equipment.
I hope this helps. Pete
Overall stud length is approximately 52mm:
Thread length is approximately 27mm:
Thread is M12 x 1.5
As far as I can see, all the studs are the same and are almost certainly original equipment.
I hope this helps. Pete
Gassing Station | Griffith | Top of Page | What's New | My Stuff