Time for a chassis refurb?
Discussion
...I asked for zinc, as I thought the same as you...The people that coat marine equipment, advised me that aluminium has better heat resisting properties,and better saline resistance...Plus; they also said that MOST tubular structures will warp, with galvanising, regardless of pressure relief...No difference in process or price, for zinc...
Manic
Manic
Edited by hillclimbmanic on Friday 29th January 17:49
Just bog standard Rustoleum for me which got a few scrapes putting the diff back in.
I had a few doubts about how easy it would be which were confirmed this afternoon,
bit of a sequence, which I was getting wrong until it became obvious the front mounts were going to have to be last.
Handbrake cable looked ok so put that back too.
I had a few doubts about how easy it would be which were confirmed this afternoon,
bit of a sequence, which I was getting wrong until it became obvious the front mounts were going to have to be last.
Handbrake cable looked ok so put that back too.
carsy said:
Has anybody had a go with the Rustbuster Epoxy mastic 121. Looks good stuff.
Have a read of this thread Carsyhttp://www.pistonheads.com/gassing/topic.asp?t=102...
Alan461 said:
Can anyone advise on washers/spacers for the rear upper wishbone to upright? There's about a 5mm gap atm
front to rear: nut-spacer-upper wishbone bracket-pvc washer-bush/upright-pvs washer- 2x 2.5 mm spacers- rear upper wishbone bracket-spacer - bolt head
(hope it makes sense...)
Frank
Alan461 said:
Can anyone advise on washers/spacers for the rear upper wishbone to upright? There's about a 5mm gap atm
Have a read of this Alan. Adrian@ explains it well.http://www.pistonheads.com/gassing/topic.asp?h=5&a...
bluezeeland said:
Alan461 said:
Can anyone advise on washers/spacers for the rear upper wishbone to upright? There's about a 5mm gap atm
front to rear: nut-spacer-upper wishbone bracket-pvc washer-bush/upright-pvs washer- 2x 2.5 mm spacers- rear upper wishbone bracket-spacer - bolt head
(hope it makes sense...)
Frank
The spacers must have escaped somehow
carsy said:
Alan461 said:
Can anyone advise on washers/spacers for the rear upper wishbone to upright? There's about a 5mm gap atm
Have a read of this Alan. Adrian@ explains it well.http://www.pistonheads.com/gassing/topic.asp?h=5&a...
No surprise on stumbling upon something that looks straight forward and finding anything but.
Gassing Station | Griffith | Top of Page | What's New | My Stuff