Bracket brake regulator (take 2)

[HvdWeerden]

If there is enough interest I will have another 10 brackets made in Stainless Steel.
Price will be UKP 15,- ex shipping. (Paypal to keep transaction costs low)

So far I have listed :

Scoobimax
PompeyTim
geappleton
greymrj
GadgeS3C




Han

Edited by HvdWeerden on Tuesday 26th June 20:07

[HvdWeerden]

phillpot said:

Han if you look close you may see I made a little "mod". drilled a 6mm hole between the spot welds, brazed a nut on and a bolt screwed in to tighten against the valve.

The idea was to stop it moving and scratching the paint (normally there is only a clip at the rear). Still managed to chip the paint so hence the grey tape around it to act as a kind of grommet.

Hello Mike,

Thanks for the tip , will have a look to improve the bracket.

Han