kaltstart relay
Discussion
Hi Glen
Yes it is the green relay for a 2.8 its a Ford NO 68-125
I have tried 2 motor factor,a ford dealers,sprint adverts,ebay,many hours on the net,and can not find one,
I have not taken it apart yet to clean it, but that was the next step if I could not get a replacement
Thanks for the other 2 contacts I will try them tomorrow
Yes it is the green relay for a 2.8 its a Ford NO 68-125
I have tried 2 motor factor,a ford dealers,sprint adverts,ebay,many hours on the net,and can not find one,
I have not taken it apart yet to clean it, but that was the next step if I could not get a replacement
Thanks for the other 2 contacts I will try them tomorrow
Hi Phillpot
The green hot start module in your diagram is the same one,
When the engine is cold,the thermotime switch triggers the kalt start relay into switching on the cold start injector which in turn injects additional fuel into the engine,
As the engine warms up the cold start injector is switched off.
The green hot start module in your diagram is the same one,
When the engine is cold,the thermotime switch triggers the kalt start relay into switching on the cold start injector which in turn injects additional fuel into the engine,
As the engine warms up the cold start injector is switched off.
Hi glen
Yes I tried the 2 contacts you gave me with no luck
The sell the relays with the looms so do not keep any in stock
I still have not opened the relay up yet as I can still just about about get it started with a small knock,
If I open It up Im afraid I might do more damage than good
Thanks any for the contacts
Yes I tried the 2 contacts you gave me with no luck
The sell the relays with the looms so do not keep any in stock
I still have not opened the relay up yet as I can still just about about get it started with a small knock,
If I open It up Im afraid I might do more damage than good
Thanks any for the contacts
Thanks to you all for the good comment and photo's
The contacts look simple to clean with a small diamond contact file to make a good flat contact
As for the electronics there do not seem to be much on the pc board a few transistors few resistors ,capacitors
If cleaning do not work there could be a dry joint on the solder,or a component faulty
.
Thanks again
The contacts look simple to clean with a small diamond contact file to make a good flat contact
As for the electronics there do not seem to be much on the pc board a few transistors few resistors ,capacitors
If cleaning do not work there could be a dry joint on the solder,or a component faulty
.
Thanks again
Gassing Station | S Series | Top of Page | What's New | My Stuff