Rubber sheet

[jned2]

Thankfully nothing to do with any bed wetting problems; what thickness rubber sheet is usually used between the chassis and body at the mounting points and is it the same thickness at all the various points?

[jned2]

Thanks both. Thinking about it ,it does make sense to drop the body first to gauge the depth of packers that are needed then lift and fit them. Am I correct in thinking that the chassis and the body should not be in direct contact ?

[jned2]

Couldn't agree more about taking plenty of photos, wish I had. Also lifting and lowering the body several times on your own using a block and tackle at the rear and 2 trolley jacks at the front is a lot harder than it sounds. My advice would be to get as many pairs of eyes to help, especially when lowering the body, to make sure the fit is perfect.