Spigot bearing

[phillpot]

Anyone got the dimensions please ?

15mm ID x 21mm OD seems to be common to a lot of Fords ?

ETA, just thought, I've got a spare gearbox, just had a measure of first motion shaft and the 15mm bit is looking good.

Did I see someone on here a while back had made a removal tool from a Rawlbolt?

Edited by phillpot on Tuesday 25th January 22:15

[phillpot]

Thanks Bob, never seen it done, but was also told that way many years ago.

The Rawlblot and bracket looks a bit less messy so (when I get around to it) will try that first but have the grease and big hammer in reserve

[phillpot]

Could be that the "grease 'n hammer" works better with larger diameter bearings like these used on older Fords

[phillpot]

greymrj said:

The Alternative Parts List covers the crankshaft spigot bearing and gives the dimensions.

Thanks, didn't think to look there.
But not totally clear ? quotes 2.8 engine and says later engines may be larger ?

Hope not, I've orderd the 15/21mm bearing

[phillpot]

Slipped the gearbox out yesterday, changed the thrust bearing, hopefully sorted oil leak and while it was out changed the spigot bearing.

Thanks for the removal tool idea, worked a treat !

Old bearing still attached in photo ........