3 angle Valve Cutting in the North East
Discussion
Hi folks,
Called up Engine Services in Dunston today to get some of my development cylinder heads sorted with valve seat cutting. Seats are in good nick and have enough material to cut slightly bigger valves into. To my surprise they don't do 3 angle seats. Another business, that I've only seen poor long block work from, quoted my eyes out after quoting quite literally 1/9th of the cost at first on the phone at first, before completely going back on themselves. At that point I may as well spend twice and buy the appropriate cutter for the Bridgeport and do it myself. I'm based in Durham and don't mind a drive. Who can cut valves and valve seats for reasonable money? Perhaps they can supply valves too if their price is reasonable.
Called up Engine Services in Dunston today to get some of my development cylinder heads sorted with valve seat cutting. Seats are in good nick and have enough material to cut slightly bigger valves into. To my surprise they don't do 3 angle seats. Another business, that I've only seen poor long block work from, quoted my eyes out after quoting quite literally 1/9th of the cost at first on the phone at first, before completely going back on themselves. At that point I may as well spend twice and buy the appropriate cutter for the Bridgeport and do it myself. I'm based in Durham and don't mind a drive. Who can cut valves and valve seats for reasonable money? Perhaps they can supply valves too if their price is reasonable.
Edited by geordiepingu on Tuesday 17th May 21:14
Gassing Station | North East | Top of Page | What's New | My Stuff