Front ARB droplinks won't fit

[Alan461]

Worried I've not put this together properly, the arb looked as if it would fit either way but the drop links won't fit with new polybushes, they won't reach the arb when it's all offered up.
I'm hoping there's something obvious I've missed

[Alan461]

Thanks, this would explain it, I was expecting them to fit plum vertical

[Alan461]

Got them to fit vertically so the drop links are perpendicular to the arb

sorry about the trackrod, not been fettled yet, the stilsons have left their usual prints

[Alan461]

Wasn't happy with the angle the droplink took, they had worn where they had been at such a difficult angle previously, had to bite the bullet and cut the eye off the tie bar and move it along a bit so it lined up with the end of the arb.


Had to use quite a lot of current and edge prep to get a deep run of weld

Edited by Alan461 on Tuesday 25th July 21:14