Rear wheel bearings etc

[david.h]

Can someone confirm the SKF No for a pre A frame RWBg for a 2.8i? I had VKBA 624, but my bearing stockist doesn't recognise it.Told him to try harder !!I have seals NA 548 [was C1002 I think]. While I am at it I suppose the tie rod bushes better be replaced, any advice ? What about trailing arm pins and bushes ? are they "readily" available ? Might as well have all the grief at once !!!

[david.h]

Thanks for info so far.Who are RT ?..for bushes. I have access to a 10 ton press and 3/4 drive sockets & torque wrench, so that bit is covered. If no-one has noted the part no on the bearing I'll have to wait until I get it out. I too have the Ford No, but I haven't been able to x-refer it yet.

[david.h]

Take note, I will say this only once !!! Quinton Hazell No is QWB 140C, MOTAQUIP and NSK seem to both use VBK codes, but I haven't verified VBKA624, Other checked options are "Premier" BRT276,and Timken EK73544. I have been quoted £ 25 for the QH kit[for Mk 2 Granada], which includes one seal and is one side, not an "axle" set. I paid £2 for Payen NA548 seals at an autojumble...buy now while stocks last!Thanks everyone.