Bulk head brake clutch connection - transition block?
Discussion
Hi
Hi all
So next question!
When we took the body off the brake pipes into the baulk head had been tightened up so much that they would not undo using an open or brake spanner, so the lines were cut not the end of the world with a complete strip as replacing anyway
So 2 of the 3 nuts have come out of the block but the last has failed and sheared off leaving the remains (brass nut and copper tube) in the block, so questions are
What is this connection is it a transition piece block from the master cylinder splitting the feeds into 3?
Any suggestions to get this out without stripping it away and having to take apart the pedal box etc.? use a stud extractor….
Thanks in advance
Alex
Hi all
So next question!
When we took the body off the brake pipes into the baulk head had been tightened up so much that they would not undo using an open or brake spanner, so the lines were cut not the end of the world with a complete strip as replacing anyway
So 2 of the 3 nuts have come out of the block but the last has failed and sheared off leaving the remains (brass nut and copper tube) in the block, so questions are
What is this connection is it a transition piece block from the master cylinder splitting the feeds into 3?
Any suggestions to get this out without stripping it away and having to take apart the pedal box etc.? use a stud extractor….
Thanks in advance
Alex
Gassing Station | General TVR Stuff & Gossip | Top of Page | What's New | My Stuff