Rovergauge Linux Ubunto

[DavidV]

I am trying to install the rovergauge software on my PC which is Linux Ubunto for use with a TVR (trying to establish root cause of failed emissions) I have downloaded the software to 'downloads' but cannot get any further, does anyone have experience of doing this on Linux or can help ?

[DavidV]

Thanks for feedback, I eventually managed to get rovergauge loaded but I am now having problems trying to connect to the serial port. After sometime I think I have managed to find the port name, see below:

[ 0.140797] printk: console [tty0] enabled
[ 22.209399] dw-apb-uart.8: ttyS4 at MMIO 0x82324000 (irq = 4, base_baud = 115200) is a 16550A
[ 22.222043] dw-apb-uart.9: ttyS5 at MMIO 0x82322000 (irq = 5, base_baud = 115200) is a 16550A
[ 22.235644] dw-apb-uart.10: ttyS6 at MMIO 0x82320000 (irq = 7, base_baud = 115200) is a 16550A
[ 137.200292] usb 1-1: FTDI USB Serial Device converter now attached to ttyUSB0

but in rover gauge, see below, I get the following error message:



Any ideas would be most welcomed, PS it works fine with windows so I guess its something I am doing wrong with Linux.

[DavidV]

Yes ignition on and pump running, it works fine in Windows so cable etc must be OK. I just feel I must be missing something with the serial port ref i.e 'ttyUSB0' have tried different combinations i.e /dev/ttyUSB0.

[DavidV]

thanks for your efforts, I will have to do a little more head scratching !

[DavidV]

thanks for your efforts, I will have to do a little more head scratching !