RV8 High Performance clutch options?
Discussion
I have a McLeod RST clutch fitted which has always been very heavy in operation, apparently it shouldn't be! It's just split and bent my clutch fork.
McLeod have offered to check the pressure plate which means sending to the US which is costly and will take time.
My thoughts are in biting the bullet and putting in something completely different.
The master, slave and fork are all good or new.
Criteria is that ideally I want an OE feel to the peddle and that it must handle 400bhp and 430 ft lb.
There doesn't seem to be many, (any) real options out there so I thought that someone should have an alternative, any ideas?
My lightweight flywheel is drilled for the McLeod twin plate spacing, (10.5" dia I believe).
Tuscan racers, (RV8), what are you using?
McLeod have offered to check the pressure plate which means sending to the US which is costly and will take time.
My thoughts are in biting the bullet and putting in something completely different.
The master, slave and fork are all good or new.
Criteria is that ideally I want an OE feel to the peddle and that it must handle 400bhp and 430 ft lb.
There doesn't seem to be many, (any) real options out there so I thought that someone should have an alternative, any ideas?
My lightweight flywheel is drilled for the McLeod twin plate spacing, (10.5" dia I believe).
Tuscan racers, (RV8), what are you using?
Well given the options, I am going to send the RST back to McLeod as they requested as there may be a fault with it, (their suggestion).
I have something coming from Powers tomorrow so will have a looksee but i don't think that the bolt pattern will fit.
You modify something, move down the line, modify again and repeat!
I have something coming from Powers tomorrow so will have a looksee but i don't think that the bolt pattern will fit.
You modify something, move down the line, modify again and repeat!
Gassing Station | TVR Major Mods | Top of Page | What's New | My Stuff