1986 Peugeot 205 engine swap

1986 Peugeot 205 engine swap

Author
Discussion

Carl.S

Original Poster:

5 posts

43 months

Monday 14th September 2020
quotequote all
Hi everyone,

I'm new to PH and not exactly a great mechanic, so bear with me.

I have a 1986 Peugeot 205 with the 1.4 twin weber XY8 in it. It has clearly seen better days, as the block and the head can't create a solid seal (need to top off coolant every once in a while, and there is a visual stain where the two meet). Had a mechanic take a look at it, and he says it needs a new block at the very least. Personally, I'd quite like to throw something else in there, but it's my understanding that the subframe is different compared to the later TU cars, making a straight swap impossible, or at the very least difficult.

However, a 1989 CTI 1.6 popped up for sale as a parts car. It's been written off due to a fire in the cabin, but the seller notes that the engine and gearbox are fine (have my doubts.), but that the wiring loom may have been damaged. Again, I'm not too mechanically inclined, but I wonder if I could transplant the front subframe assembly, as well as the engine and gearbox.

I suppose my question is, have I completely lost my bearings, or should I pursue this idea. The rest of the car is in good, original condition, so I think it's too nice to just junk it.


EDIT: Image - That's where the block meets the head


Carl.S

Original Poster:

5 posts

43 months

Monday 14th September 2020
quotequote all
I think the head was off recently. It's very shiny compared to anything else in the engine bay. Goes without saying that I bought it a couple of months ago.

Carl.S

Original Poster:

5 posts

43 months

Wednesday 16th September 2020
quotequote all
Old Merc said:
Your 205 XY8 is the old "Lay flat" flat engine with the gearbox in the sump. Its all aluminium with steel wet liners, notorious for head gasket failure. Its very difficult to remove and refit the head insitue, best to do it with the engine removed. Expect to find the head corroded beyond repair, cylinder block corroded, liner protrusion low. You will be on a hiding for nothing.

The 205 CTI has the XU GTi engine with conventional gearbox, the subframe, suspension, driveshafts etc etc, completely different. If the car had a cabin fire I`m sure the engine ECU has been toasted.

Its an interesting idea OP, but my advice is to forget it. Advertise your 205 for spares on www.clubpeugeotuk.org , I`m sure you will get some money for it.

Edited by Old Merc on Tuesday 15th September 17:26
Yeah, was worried about that...

Might just put it away somewhere, buy something else as a daily driver, and relegate it to a fun weekend car where I can eventually find something to put in it down the line.

Carl.S

Original Poster:

5 posts

43 months

Tuesday 22nd September 2020
quotequote all
megamaniac said:
i have some ecu's if that helps,would be glad to get rid of them.
Thanks for the offer, but I think someone else bought the CTi (listing is down). Going to try and find a drop-in replacement engine at some point, st as they may be.