Helix clutch 6 paddle noise
Discussion
Hi All,
I have a 2012 JCW tuned to around 390nm and 280 BHP. Had to upgrade the clutch for something that can take the upgraded power. Went for the helix 6 paddle clutch kit with single mass flywheel. Problem is that im getting a lot of noise when pulling off from a standstill. Major issue when in traffic... Has anyone else had this issue??
I have a 2012 JCW tuned to around 390nm and 280 BHP. Had to upgrade the clutch for something that can take the upgraded power. Went for the helix 6 paddle clutch kit with single mass flywheel. Problem is that im getting a lot of noise when pulling off from a standstill. Major issue when in traffic... Has anyone else had this issue??
Sorry for the late response. I dont have any noise at idle, only when i set off and the clutch is engaging, also if when your driving and you dont rev matc and let the revs drop then bring up the clutch you get the noise again...
It sounds like clutch doesnt like the SMF.
It sounds like clutch doesnt like the SMF.
Edited by Cptditch on Monday 24th April 11:47
Im not sure. Lohen did the work, but they are having the same noise issue on their project car too. Also read this http://www.minitorque.com/forum/f847/helix-6-paddl... which may mean its a common issue. VERY loud noise.
At the moment Lohen dont have any alternative, what i dont understand is why other people are having no issues with the clutch...
Is it down to fitting? no idea? Lohen seem like a good outfit so cant see why there would be an issue there.
At the moment Lohen dont have any alternative, what i dont understand is why other people are having no issues with the clutch...
Is it down to fitting? no idea? Lohen seem like a good outfit so cant see why there would be an issue there.
Edited by Cptditch on Wednesday 3rd May 16:41
Gassing Station | New MINIs | Top of Page | What's New | My Stuff