TPS Only Goes to 95%: How to Adjust Throttle Cable

[karmavore]

I finally got freescan running and noticed that with the engine off the TPS will only reach 95% (is this a magic number?) with the pedal planted.

I can't find directions in the service notes. How and where do I adjust it?

Thanks so much guys.

Luke.

[karmavore]

Thanks, but I'm a little confused.

The cable has a little slack at both ends. Not a lot, but it's not taught either.

Should I adjust at the TB or pedal end?

Also, when adjusting the pedal am I actually adjusting the cable (I don't see how)or the bolt that stops the pedal from travling?

Thanks Doc.

Luke.

[karmavore]

Paula&Marcus said:

Hi Luke, Yes, everything above 96% is a magic number. Cheers Marcus

On the 4s too? Very interesting... Thank you Marcus!

[karmavore]

All fixed. I reset the BLM and can't wait till morning.

[karmavore]

GreenV8S said:

Worth checking whether the 95% means the throttle plate is not opening fully (pedal/cable/throttle assy issue) or the throttle pot is saying 95% when the throttle is fully open (throttle pot calibration issue).

I adjusted the bolt and got it to read 100% so I imagine that was all it was. Thanks.

Luke.