ring tone wheel for traction control

[ROWDYRENAULT]

Hi Guys: trying to install traction control on the new Ultima. I went to the English Traction control .com site and they show a wheel for the Ultima. yea! well guess what, when I ordered them a nice man from that factory E mailed me and told me to check clearance around the hub. their wheel is about 2 mm to small. Not complaining at least they where thoughtful enough to ask before they sent them.
Now I am looking for an alternative solution before committing the bucks to have a set machined. Any ideas . lee

[ROWDYRENAULT]

Thanks for the input guys, but that is the company that I was looking at. After ordering it, because as you noted it specifically indicates that its for a ultima, I got a note from the company asking me to check the Diameter of the drive hub. their center hole is 135mm and our hubs are 135.36. The wheel studs are to close to the edge of the hub for me to consider turning down the hub. I have asked if they can change the design to facilitate our hubs, no answer so far but its early Monday. If this fails I will have my friendly CNC shop make me a set, but the cost will be 3 to 4 times the cost . Lee

Edited by ROWDYRENAULT on Monday 28th August 16:30