Hole punch or drill ?

[pilbeam_mp62]

Have any builders used a 1/8 inch hole punch rather than a 3.2mm drill for making the holes in
the aluminium panelling ? It seems like it would be a lot quicker and would not need de-burring.
Any views ?

Thanks very much,
Regards

Kelvin

[pilbeam_mp62]

Steve_D said:

The remaining holes are then drilled through both the panel and chassis in one operation ensuring they align correctly.
Steve

That was the bit I was not sure about - but you have answered it perfectly for me - thanks you very much Steve.

Regards
Kelvin

[pilbeam_mp62]

Mart,

These look like an ingenious solution to the spacing problem - I can't tell the difference between the two pictures - they both look the same to me !! ?? - Would you recommend the Small, the Large or both...?

Thanks very much,
Regards

Kelvin

[pilbeam_mp62]

Thanks very much Mart.
Regards

Kelvin