Raw metal radiators
Discussion
Trying to find modern rads in raw metal (lacquered)
All I can seem to find are fairly traditional ‘school’ radiators and although I really like them, my house is probably a bit too modern to carry them off.
Anyone know of anywhere I can get either horizontal panel or tube rads in raw metal?
Tia...
All I can seem to find are fairly traditional ‘school’ radiators and although I really like them, my house is probably a bit too modern to carry them off.
Anyone know of anywhere I can get either horizontal panel or tube rads in raw metal?
Tia...
From here - https://loveradiators.com/MHS-Multisec-Bespoke-Mad...
Very helpful people.
I’ve had one bespoke as I needed a total of 8000btu over two rads, but wanted a specific size and only two columns on one of the rads.
2 columns
Depth: 66mm
Height: 500mm
Width: 990mm
Output: 2873
£412.92
3 columns
Depth: 107mm
Height: 600mm
Length: 1220mm
Output: 5783
£580.00
Very helpful people.
I’ve had one bespoke as I needed a total of 8000btu over two rads, but wanted a specific size and only two columns on one of the rads.
2 columns
Depth: 66mm
Height: 500mm
Width: 990mm
Output: 2873
£412.92
3 columns
Depth: 107mm
Height: 600mm
Length: 1220mm
Output: 5783
£580.00
dazm said:
Look like mine which are made by 'revive' I think. Got mine from mrcentralheating.co.uk who seemed to be the cheapest I could find at the time. Also have zehnder versions in which which really show up Just how much dust they gather! The raw metal ones don't show this and everyone comments on how good they look
Mr central heating are very cheap in comparison, but don’t do the sizes I needed.Too traditional for mine - I’ll need to have normal ones.
Found these in black nickel
https://www.columnradiators4u.co.uk/uk/modern-trv-...
Found these in black nickel
https://www.columnradiators4u.co.uk/uk/modern-trv-...
I’ll post a pic of the bracket when I get home today.
If the brackets won’t work for you, you can also get feet for these rads to make them floor standing.
Could then just add a couple of stays to hold the rad safely to the wall.
https://www.castrads.com/stays-fixings/#!f?categor...
If the brackets won’t work for you, you can also get feet for these rads to make them floor standing.
Could then just add a couple of stays to hold the rad safely to the wall.
https://www.castrads.com/stays-fixings/#!f?categor...
The Dangerous Elk said:
Why would you fit those and not Cast Iron ones and benefit from the "heat sink" of the iron >?
For me, these are just that bit more contemporary than chunky iron ones.Iron ones also tend to be floor mounted which I don’t want. (and incredibly heavy and slow to warm up)
And, I prefer the look of these
Gassing Station | Homes, Gardens and DIY | Top of Page | What's New | My Stuff