How to check for leaking slave cylinder - Ford Focus
Discussion
Wondering if someone can provide a bit of advice as I may or may not have a problem with my slave or master cylinder.
I have a 2004 ford focus 1.6. which has done 120k miles. I've only had it 2 years so I only know the cam belt has been done recently.
The biting point of my clutch pedal is very high, says 3/4 of the way from the clutch pedal being fully released but im not sure if this has always been the case since i've had the car, or if its a recent development.
I also have a an issue with the break pedal, sometimes its spongy while other times its firm, although this doesnt seem to affect the breaking performance.
I was advised that it sounds like the slave cylinder may be leaking. Is there any checks I can do to test this?
Also, the mechanic said that its wise to replace the clutch if the slave cylinder needs doing and quoted £240. Is a clutch replacement advisable in this scenario and if so is £240 reasonable?
Thanks in advance.
I have a 2004 ford focus 1.6. which has done 120k miles. I've only had it 2 years so I only know the cam belt has been done recently.
The biting point of my clutch pedal is very high, says 3/4 of the way from the clutch pedal being fully released but im not sure if this has always been the case since i've had the car, or if its a recent development.
I also have a an issue with the break pedal, sometimes its spongy while other times its firm, although this doesnt seem to affect the breaking performance.
I was advised that it sounds like the slave cylinder may be leaking. Is there any checks I can do to test this?
Also, the mechanic said that its wise to replace the clutch if the slave cylinder needs doing and quoted £240. Is a clutch replacement advisable in this scenario and if so is £240 reasonable?
Thanks in advance.
Gassing Station | General Gassing | Top of Page | What's New | My Stuff