M Series bumpers
Discussion
plasticpig72 said:
Adrian Venn does good grp Bumpers.
I was lucky and was given 4 cut down corners from a Triumph 2000. A friend tig welded closing plates. Then i got them rechromed for 400 Euros.
Alan
I think I may have seen an old post that showed what you had, they did look good in metal!I was lucky and was given 4 cut down corners from a Triumph 2000. A friend tig welded closing plates. Then i got them rechromed for 400 Euros.
Alan
Has anyone dealt with SC who supply metal ones I wonder?
catfishdb said:
Hi Mark,
I believe Adrian Venn has a version. Someone out there sells a plastic version as opposed to the rubber ones.
I just can't remember where I saw them.
Now that you have asked the question I am going to hang out here and see who comes along.
I think I want a plastic set. I am under the impression I can tailor them to sit close to the body with minimal gaps.
Arthur
Thanks Arthur, don’t blame you, taking this approach I think would look good.I believe Adrian Venn has a version. Someone out there sells a plastic version as opposed to the rubber ones.
I just can't remember where I saw them.
Now that you have asked the question I am going to hang out here and see who comes along.
I think I want a plastic set. I am under the impression I can tailor them to sit close to the body with minimal gaps.
Arthur
I may give Adrian a bell, I’m sure he’d have some good advice regardless.....
Fishermt said:
Harrington are advertising stainless steel ones that look very smart in the pictures- currently reduced to £729 inclusive of postage.
https://groupharrington.com/product/tvr-1600m-2500...
Thanks for this, will have to see if the bank balance can handle it 😬https://groupharrington.com/product/tvr-1600m-2500...
Gassing Station | TVR Classics | Top of Page | What's New | My Stuff