Interest in 4.5 throttle linkage bar
Discussion
Having recently adjusted the throttle, throttle pots, and balanced the flow etc i found the throttle linage bar to be rubbish.
So because of this i am going to be making some new ones, using stainless steel.
They will consist of a proper left hand thread and right hand thread. and hex bar in the centre to help with adjustment if a spanner is needed. will be able to be used with the existing ball joints or rose joints that i have recently upgraded to.
Will be using 5mm threaded bar so the same as the original but offer better adjustment and more secure from coming undone like mine did as i had to remove one of the lock nuts to get the adjustment needed.
i have enough material for about three, one being for myself so have two to offer here.
£25 posted. first come first served.
Peter
So because of this i am going to be making some new ones, using stainless steel.
They will consist of a proper left hand thread and right hand thread. and hex bar in the centre to help with adjustment if a spanner is needed. will be able to be used with the existing ball joints or rose joints that i have recently upgraded to.
Will be using 5mm threaded bar so the same as the original but offer better adjustment and more secure from coming undone like mine did as i had to remove one of the lock nuts to get the adjustment needed.
i have enough material for about three, one being for myself so have two to offer here.
£25 posted. first come first served.
Peter
I've been working out all the material, costs & postage
4.2 version £36.50 posted
4.5 version £34.50 posted
If you are interested you can PayPal me the money to pmessling@blueyonder.co.uk please state version and your address.
if you want to send cheques please email me at the above address for my postage address.
Peter.
4.2 version £36.50 posted
4.5 version £34.50 posted
If you are interested you can PayPal me the money to pmessling@blueyonder.co.uk please state version and your address.
if you want to send cheques please email me at the above address for my postage address.
Peter.
They are all now made. Just waiting on a rose joint after one consumed a tap. So should be with everyone come end of the week, beginning of next.
I don't have a couple of addresses but will email those tomorrow once back with my laptop.
I have over sized the threaded rod in length. That is for the individual to cut down to size as each car is different.
Peter
I don't have a couple of addresses but will email those tomorrow once back with my laptop.
I have over sized the threaded rod in length. That is for the individual to cut down to size as each car is different.
Peter
Gassing Station | Cerbera | Top of Page | What's New | My Stuff