Engine and Gearbox mounts
Discussion
Evening all,
My car has developed a judder when moving off from standstill. It only happens when the car is has been running for a while and I'm assuming that the heat from the engine is softening what are probably knackered mounts and exacerbating the problem.
Do you think this is likely? If so, can you confirm the number required? I'm assuming it's Engine x 2 and Gearbox x 2
Many thanks
Ian
My car has developed a judder when moving off from standstill. It only happens when the car is has been running for a while and I'm assuming that the heat from the engine is softening what are probably knackered mounts and exacerbating the problem.
Do you think this is likely? If so, can you confirm the number required? I'm assuming it's Engine x 2 and Gearbox x 2
Many thanks
Ian
Afternoon all,
I've changed three of the four mounts so far. The drivers side engine mount is beating me at the minute. Everything is loose but I'm struggling to get enough clearance to unscrew the mount. What am I missing? Do I have to remove the fabricated bracket that is bolted to the chassis rail?
Any tips would be greatly appreciated as I was hoping to be out enjoying this great weather.............
Cheers
Ian
I've changed three of the four mounts so far. The drivers side engine mount is beating me at the minute. Everything is loose but I'm struggling to get enough clearance to unscrew the mount. What am I missing? Do I have to remove the fabricated bracket that is bolted to the chassis rail?
Any tips would be greatly appreciated as I was hoping to be out enjoying this great weather.............
Cheers
Ian
ukkid35 said:
billybradshaw said:
Afternoon all,
I've changed three of the four mounts so far. The drivers side engine mount is beating me at the minute. Everything is loose but I'm struggling to get enough clearance to unscrew the mount. What am I missing? Do I have to remove the fabricated bracket that is bolted to the chassis rail?
Any tips would be greatly appreciated as I was hoping to be out enjoying this great weather.............
Cheers
Ian
It is possible that the steering shaft is the problem.I've changed three of the four mounts so far. The drivers side engine mount is beating me at the minute. Everything is loose but I'm struggling to get enough clearance to unscrew the mount. What am I missing? Do I have to remove the fabricated bracket that is bolted to the chassis rail?
Any tips would be greatly appreciated as I was hoping to be out enjoying this great weather.............
Cheers
Ian
If you do loosen the UJs to remove it bear in mind that it is almost impossible to tighten them sufficiently to remove all play. I ending up replacing the bolts for 12.9 versions and then using stupid amounts of torque.
Ta
Ian
Gassing Station | Cerbera | Top of Page | What's New | My Stuff