Heater controls & temp gauge removal...
Discussion
Just bought the Leven S/steel dash, I've removed the speedo & rev counter, but how does the fitting come out the back of the temp gauge? Don't want to break the bloody thing!
Also about to tackle the heater/fan controls are they removed by undoing the grub screws that hold their knobs on,()and then removing the exposed nut on this spline?
Our is it held in from behind the dash?
Any help greatly appreciated guys
Also about to tackle the heater/fan controls are they removed by undoing the grub screws that hold their knobs on,()and then removing the exposed nut on this spline?
Our is it held in from behind the dash?
Any help greatly appreciated guys
Thanks BB, looks like the way to go then.
What happens should the temp gauge need replacing, surely that copper fitting must come out of the gauge somehow?
How did you get on with the pcb board mounted on the back of the original dash, is it easy to swap over to the new dash (does the new dash have the mounting studs, already on it?) or do I need to get the glue gun ready to fix my own studs to it?
What happens should the temp gauge need replacing, surely that copper fitting must come out of the gauge somehow?
How did you get on with the pcb board mounted on the back of the original dash, is it easy to swap over to the new dash (does the new dash have the mounting studs, already on it?) or do I need to get the glue gun ready to fix my own studs to it?
Gassing Station | Cerbera | Top of Page | What's New | My Stuff