Help Please - Mallory Distributor on Rover V8
Discussion
I've been having some ignition problems on the 3.5L SD1 Rover V8 in my kit car, and know they have notoriously unreliable distributors so at the weekend invested in a Mallory Dual Point dizzy along with new coil and ballast resistor.
Now I'm afraid to say I'm not sure how to wire everything up!
I'm currently using the old SD1 ballast resistor with six connections to it. Not sure how the new ballast resistor (a simple two connection jobby) can replace it? Do I wire it in as well, in series in the feed to the coil positive? Or do I leave some connections on the old ballast resistor and move some over to the new one?
Anyone ever done this swap or know what I need to do? Sorry if this is a bit of a dumb question but any help gratefully appreciated.
Thanks,
Chris
Now I'm afraid to say I'm not sure how to wire everything up!
I'm currently using the old SD1 ballast resistor with six connections to it. Not sure how the new ballast resistor (a simple two connection jobby) can replace it? Do I wire it in as well, in series in the feed to the coil positive? Or do I leave some connections on the old ballast resistor and move some over to the new one?
Anyone ever done this swap or know what I need to do? Sorry if this is a bit of a dumb question but any help gratefully appreciated.
Thanks,
Chris
Thanks for the ideas guys. Can't get to the car right now to take a digital pic but I've dug out my old SD1 Haynes manual and tried to decipher the wiring diagram. Seems like the six connections on the old SD1 ballast resistor module are to starter motor, ignition switch and tacho on one side of the module. And on the other side there's one to the coil positive, one to the coil negative and distributor, plus another one to the distributor.
I presume the two connections to the SD1 distributor are to do with it being a (crappy) electronic system. The new Mallory one only has a single connection to it to presumably one of the existing wires becomes redundant.
Any more ideas gratefully received. I'm also trying to see if I can get hold of someone at Real Steel (who sold me the bits) who knows how to fit it but so far no luck.
Chris
I presume the two connections to the SD1 distributor are to do with it being a (crappy) electronic system. The new Mallory one only has a single connection to it to presumably one of the existing wires becomes redundant.
Any more ideas gratefully received. I'm also trying to see if I can get hold of someone at Real Steel (who sold me the bits) who knows how to fit it but so far no luck.
Chris
Fair point! I went for the Mallory dual points because I have read lots of stuff about it being well proven in various Hi-Power Rover V8 engines, including some drag cars. Mallory do however do an all electronic version as you suggest (about an extra £100 IIRC - which would be OK) but I've not heard much about it one way or the other.
Wondering now whether I should have gone that route in the first place. Maybe I could still swap it, the one I bought hasn't gone in the car yet.
With my skills (or rather lack of) i'll probably still manage to struggle with the wiring though!
Chris
Wondering now whether I should have gone that route in the first place. Maybe I could still swap it, the one I bought hasn't gone in the car yet.
With my skills (or rather lack of) i'll probably still manage to struggle with the wiring though!
Chris
Gassing Station | Engines & Drivetrain | Top of Page | What's New | My Stuff