Fast Cold Idle
Discussion
I think this has been discussed before but cant find the thread.Started the Griff 400 and all well until I touched the throttle, now idles over 2000rpm, the plenum throttle is closed fully, stuck stepper motor?
Did this once before months ago but cured itself.
Any advice guys?, any info gratefully received.
Thanks in advance,
Griffer
Did this once before months ago but cured itself.
Any advice guys?, any info gratefully received.
Thanks in advance,
Griffer
robperrie, the stepper is at the rear drivers side of the intake plenum,use 1/1/8" spanner or adjustable to remove after undoing the loom connector,clean the conical tip of all carbon and the seat in the plenum with a bit of rag on a stick, dont scratch it though.
There is a thin sealing washer on the stepper and thats where mine was leaking.Dont overtighten or you will bust it. Good luck.
Griffer
There is a thin sealing washer on the stepper and thats where mine was leaking.Dont overtighten or you will bust it. Good luck.
Griffer
Gassing Station | Engines & Drivetrain | Top of Page | What's New | My Stuff