Rover V8 Ignition wiring, HELP!
Discussion
Hi guys and galls,
I'm putting a 3.5 rv8 into my mgb, got most of the wiring done but have come a little unstuck on the wiring for the coil, and distributer etc...
By the way its a 3.5 sd1 engine runnng carbs (not efi)
So if anyone can advise me on how the wiring should go any help would be much appresiated, thanks
I'm putting a 3.5 rv8 into my mgb, got most of the wiring done but have come a little unstuck on the wiring for the coil, and distributer etc...
By the way its a 3.5 sd1 engine runnng carbs (not efi)
So if anyone can advise me on how the wiring should go any help would be much appresiated, thanks
hi there, the coil is a range rover v8 12v type. I dont think the dizzy is electronic as cant see an ignition amp anywhere, but as you can tell wiring isnt my strong point. Here is a pic of the dizzy, as you can see theres red, black and blue, so i guess pos, neg, but not sure what blue is.
The wiring on the b has 2 wires going to the coil and 1 earth from it but cant remember where they go as took the old engine out so long ago, so like I said any help much appreciated.
The wiring on the b has 2 wires going to the coil and 1 earth from it but cant remember where they go as took the old engine out so long ago, so like I said any help much appreciated.
hmmm. dont think i have it! .
Oddly i thought when i took the top off earlier I saw a set of points in there, but I'd have to check, is it possible someone could have modified it to put points in???
Annoyingly I saw the engine running in an old series landy afew months ago, but the bloke took it out for me and told me all the bits were there. I didn't double check, as was more concerned with the rest of the car at the time, oops.
I will double check tomorrow and report back with my findings, thanks
Oddly i thought when i took the top off earlier I saw a set of points in there, but I'd have to check, is it possible someone could have modified it to put points in???
Annoyingly I saw the engine running in an old series landy afew months ago, but the bloke took it out for me and told me all the bits were there. I didn't double check, as was more concerned with the rest of the car at the time, oops.
I will double check tomorrow and report back with my findings, thanks
http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&am...
be this the beastie I need??? and I assume (stupidly I expect) that the 3 wires I have should have a plug that clips in to the one under the coil?
be this the beastie I need??? and I assume (stupidly I expect) that the 3 wires I have should have a plug that clips in to the one under the coil?
http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&am...
by the way if I used this dizzy, does it have the correct drive gear for the sd1 engine??? Or will i just need to nick the bits I need and stick em on my dizzy? thanks
by the way if I used this dizzy, does it have the correct drive gear for the sd1 engine??? Or will i just need to nick the bits I need and stick em on my dizzy? thanks
Gassing Station | Engines & Drivetrain | Top of Page | What's New | My Stuff