New guy Just bought a CV8
Discussion
Hi all,
Last week I bought a monaro, it was previously owned by a member of this forum.
Ive given the wheels a change of colour, sorted the brakes as the car had had little use and the AP discs had rusted badly and the pads had glazed over.
Does anyone know if C5 Corvette engine covers will fit? OR will it need a fitting kit?
I hate the standard cover!
Also if I replace the wheels with more 18" what offset can I get away with?
Thanks for looking
Last week I bought a monaro, it was previously owned by a member of this forum.
Ive given the wheels a change of colour, sorted the brakes as the car had had little use and the AP discs had rusted badly and the pads had glazed over.
Does anyone know if C5 Corvette engine covers will fit? OR will it need a fitting kit?
I hate the standard cover!
Also if I replace the wheels with more 18" what offset can I get away with?
Thanks for looking
They are part number MDC1941. They are 360x30mm rather than 362x32. This isn't a problem and pad still make full contact.
The issue is that you need to make a centre Spiggot to fit between the hub And the disc (71.5mm to just a thou under 79mm and 7mm thick) I also made a set of ten spacers to slide over the 12mm studs to take them to 16mm of the Range Rover
Another potential issue is the mounting surface is 2mm thinner than the AP so if your wheels are close it could make it worse. I Had a pair of 3mm so popped them on until I get new wheels
The issue is that you need to make a centre Spiggot to fit between the hub And the disc (71.5mm to just a thou under 79mm and 7mm thick) I also made a set of ten spacers to slide over the 12mm studs to take them to 16mm of the Range Rover
Another potential issue is the mounting surface is 2mm thinner than the AP so if your wheels are close it could make it worse. I Had a pair of 3mm so popped them on until I get new wheels
Gassing Station | HSV & Monaro | Top of Page | What's New | My Stuff