Tyre Warmer Repair
Discussion
I sat down at the weekend to thread my tyre warmers with bungee pull cord. I spent and hour pushing it through with a pen, shouting and trying like fk to tie a bowline knot. After I finished, I then discovered my tyre warmers had became creased, and as a result burnt the fabric through and one of the wires is exposed.
Its just the front that's like that, rears fine. They are diamond ones, I called them but its been over 5 years since they stocked them and they don't repair them anymore. He says I can get heat proof fabric and knit it in. To be honest, they are fking st, the pull cord is a fking pain in the arse, the elasticated ones I tried are so much better.
so, anyone fixed theirs? or chuck it.
I'm thinking diamond again?
http://www.diasec.co.uk/diamond-tyre-heaters-448-p...
any other recommendations around the £150 mark.
Its just the front that's like that, rears fine. They are diamond ones, I called them but its been over 5 years since they stocked them and they don't repair them anymore. He says I can get heat proof fabric and knit it in. To be honest, they are fking st, the pull cord is a fking pain in the arse, the elasticated ones I tried are so much better.
so, anyone fixed theirs? or chuck it.
I'm thinking diamond again?
http://www.diasec.co.uk/diamond-tyre-heaters-448-p...
any other recommendations around the £150 mark.
Gassing Station | Biker Banter | Top of Page | What's New | My Stuff