Anyone attempted to bend an exhaust with heat?
Discussion
So, getting tore into my zxr750 project, downpipes and 4 into 2 section of exhaust were knackered!
So, started looking for stainless downpipes for it, long story short couldn't find good used set and was distracted by someone online saying zx9 B model pipes fit, bought them, fitted them fine, except, pipe up to can heads away from the swingarm a but too much for my liking.
So, i have a propane torch, what's my chances of putting heat on this and it bending slightly? Say maybe having a crowbar and bar down the pipe and pulling it inwards towards the bike while heating it down under the bike?
Will this work? Thanks!
So, started looking for stainless downpipes for it, long story short couldn't find good used set and was distracted by someone online saying zx9 B model pipes fit, bought them, fitted them fine, except, pipe up to can heads away from the swingarm a but too much for my liking.
So, i have a propane torch, what's my chances of putting heat on this and it bending slightly? Say maybe having a crowbar and bar down the pipe and pulling it inwards towards the bike while heating it down under the bike?
Will this work? Thanks!
I thought about cutting a slit, i have a mig welder but never welded stainless. Might just get someone else to weld it.
The two issues i read i might have when fitting these pipes to this bike i'm not having! But they fail to mention the arse end of the thing.
I even thought if i loosened the 4 into 2 bit twisting the rear end would make the 4 manifold pipes twist within the 4 to 2 join enough to get the rear a bit closer to the swingarm? If you know what i mean?
The two issues i read i might have when fitting these pipes to this bike i'm not having! But they fail to mention the arse end of the thing.
I even thought if i loosened the 4 into 2 bit twisting the rear end would make the 4 manifold pipes twist within the 4 to 2 join enough to get the rear a bit closer to the swingarm? If you know what i mean?
Gassing Station | Biker Banter | Top of Page | What's New | My Stuff