Absolute best lead/sock/extender solution?
Discussion
Help me out here.
I am on my third set of decent leads and now I have noticed the top of a couple of rubber boots are splitting at the top.
I am running a set of standard extenders to bring the leads up, a set of Magnacor HT leads and a set of unknown, ('cause I can't remember) socks.
I tie the leads back as much as possible to pull them from the manifolds but as you can see, they run very close.
Unfortunately being a large capacity engine, it does give off a huge amount of heat!
What is the best solution? I'm not up for saving money, just need the best fix!
I am on my third set of decent leads and now I have noticed the top of a couple of rubber boots are splitting at the top.
I am running a set of standard extenders to bring the leads up, a set of Magnacor HT leads and a set of unknown, ('cause I can't remember) socks.
I tie the leads back as much as possible to pull them from the manifolds but as you can see, they run very close.
Unfortunately being a large capacity engine, it does give off a huge amount of heat!
What is the best solution? I'm not up for saving money, just need the best fix!
Thanks guys. This gives me a few ideas to investigate.
I believe I paid over £100 for the Magnacor leads plus socks, (of dubious quality I reckon now) and so it is disappointing. From memory I had problems with the previous Magnacor set on my previous chim.
Any other ideas, please post up. They have not failed as in, shorting out or engine missing but I need to be on top of this. The engine really does produce a huge amount of heat!
I believe I paid over £100 for the Magnacor leads plus socks, (of dubious quality I reckon now) and so it is disappointing. From memory I had problems with the previous Magnacor set on my previous chim.
Any other ideas, please post up. They have not failed as in, shorting out or engine missing but I need to be on top of this. The engine really does produce a huge amount of heat!
ked! I spoke to Tim at ACT yesterday as I have their big for manifolds.
It seems to make matters worse a new sets of manifolds run slightly closer to the plug line.
I told him I was using Magnacore leads and the problem I had. He kindly called Magnacort UK direct to a guy he knows there who suggested I send leads to him and they will fit a set of high temperature plug leads ends to the leads which when used with extenders which I do use should solve the problem.
I will also order a known better make of sock and hopefully with the two together I’ll solve the problem!
It seems to make matters worse a new sets of manifolds run slightly closer to the plug line.
I told him I was using Magnacore leads and the problem I had. He kindly called Magnacort UK direct to a guy he knows there who suggested I send leads to him and they will fit a set of high temperature plug leads ends to the leads which when used with extenders which I do use should solve the problem.
I will also order a known better make of sock and hopefully with the two together I’ll solve the problem!
Gassing Station | Chimaera | Top of Page | What's New | My Stuff