Lambda sensor connector
Discussion
Thanks for the info, after some extensive searching I have found the relevant part numbers, I have shown them below just in case it is of interest to anyone some day!
ECONOSEAL-J CONN PLUG 3P part no 172201-1
Econoseal J Series Cap housing part no 172202-1
172203-1 Rubber seal
170280-1 contact pin
170295-1 contact pin
This info came from the Tyco electronics web site as they now own the AMP brand, amazingly the site is showing that 2 UK distributors hold stock for these parts, I have emailed them both, but will see what happens, experience usually shows they only want to supply in multiples of 100..
Andy
ECONOSEAL-J CONN PLUG 3P part no 172201-1
Econoseal J Series Cap housing part no 172202-1
172203-1 Rubber seal
170280-1 contact pin
170295-1 contact pin
This info came from the Tyco electronics web site as they now own the AMP brand, amazingly the site is showing that 2 UK distributors hold stock for these parts, I have emailed them both, but will see what happens, experience usually shows they only want to supply in multiples of 100..
Andy
I have had a reply from one of the distributors of these parts, good news is that both housings are in stock at about 60p & 80p each, bad news is that the crimps pins are on 12 week lead time with a MOQ of 12000!
I have asked very nicely if they could let me have a couple of hundred.
will keep you posted.
Andy
I have asked very nicely if they could let me have a couple of hundred.
will keep you posted.
Andy
Gassing Station | Chimaera | Top of Page | What's New | My Stuff