mgb b series 1.8 con rod orientation
Discussion
Hi
Thought i would start a new topic as my original one is more related to my carb (probably) woes !
I have stripped out the pistons on my roadster .
I found no2 con rod was opposite way round to the other 3 .Obviously a past slip up .
Does anyone know if it matters?
I spoke to a local engineering company that do a lot of hi end mini engine mods ,He said it isnt a problem on A series (mini engines)
He wasnt sure about B series (1.8 engines)
It means the con rod lube jet is on opposite side .
When i mentioned , that i thought it would be important to apply oil to thrust side of piston (i dont know which side that is either!)
He said no, jet is only to serve piston crown area .
Any info on this out there ?
Cheers guys
Thought i would start a new topic as my original one is more related to my carb (probably) woes !
I have stripped out the pistons on my roadster .
I found no2 con rod was opposite way round to the other 3 .Obviously a past slip up .
Does anyone know if it matters?
I spoke to a local engineering company that do a lot of hi end mini engine mods ,He said it isnt a problem on A series (mini engines)
He wasnt sure about B series (1.8 engines)
It means the con rod lube jet is on opposite side .
When i mentioned , that i thought it would be important to apply oil to thrust side of piston (i dont know which side that is either!)
He said no, jet is only to serve piston crown area .
Any info on this out there ?
Cheers guys
Gassing Station | MG | Top of Page | What's New | My Stuff