Bas*%$d flywheel :censored:
Discussion
Any ideas how to get the flywheel off this metro engine I bought?
So far broken 1 flywheel puller, now stripped the threads out of the flywheel where it bolts into
Considering trying to re-tap a bigger hole then trying to get a bolt into it, or weld the current on in, any other ideas?
So far broken 1 flywheel puller, now stripped the threads out of the flywheel where it bolts into
Considering trying to re-tap a bigger hole then trying to get a bolt into it, or weld the current on in, any other ideas?
Coming very close to torching it but after opening it up it seems the engine may of had a recent rebuild so that’s what’s stopping me.
I have a blowtorch but the threads came out before I could use it
I do have a plan though, I think I’ll get a threaded bar, wind it into the hole, then weld it to the flywheel, then put a nut down it, then weld that to the flywheel as well, hopefully that should hold!
Paul
I have a blowtorch but the threads came out before I could use it
I do have a plan though, I think I’ll get a threaded bar, wind it into the hole, then weld it to the flywheel, then put a nut down it, then weld that to the flywheel as well, hopefully that should hold!
Paul
Gassing Station | Classic Minis | Top of Page | What's New | My Stuff