Torque settings
Archive #15420157
Torque Settings lb/ft
Please Update by copying the following line, pasting at the bottom of the list, and substituting the correct values...
(*1) Thread tightening direction is in the direction of Wheel Rotation
Please Update by copying the following line, pasting at the bottom of the list, and substituting the correct values...
Description | nn |
====================
Description | lb/ft |
---|---|
Anti roll bar Rear | ? |
Anti Roll Front | ? |
Bellhousing to Gearbox | 50 |
Bellhousing to engine | 50 |
Brakes: Caliper mount to hub carrier | 40-45 |
Brakes: Caliper to Caliper mount | 40-45 |
Brakes: Caliper to carrier | 40-45 |
Brakes: line banjo bolt | 9-10 + 90 degrees |
Clutch cover to flywheel | 25 |
Diff front bracket to chassis | 95 |
Drag link to chassis | 40-45 |
Drag Link to suspension arm | 45-50 |
Front hub centre bolt | 70-75 |
Hub to hub carrier | 45-50 + loctite |
Lambda sensors | finger tight + 180 degrees |
Lower ball joint taper nut | 60-70 |
Lower ball joint to suspension | 20-25 |
Rear Hub - Driveshaft/Hub 41mm nut (*1) | 220 |
Shock Absorbers | 45-50 |
Slave cylinder to bellhousing | 15 |
Steering arm to hub carrier | 45-50 |
Track rod end taper nut | 35-40 |
Upper ball joint plate to hub carrier | 20-25 |
Upper ball joint to plate | 50-55 |
Wheel nut | 55-60 |
Wishbones Lower | 55 |
Wishbones Upper | 40-45 |
(*1) Thread tightening direction is in the direction of Wheel Rotation