Torque settings
Archive #17965980
Torque Settings lb/ft
Please Update by copying the following line, pasting at the bottom of the list, and substituting the correct values...
(*1) Thread tightening direction is in the direction of Wheel Rotation
Tracking and Camber Settings
Camber Degrees - Front and Rear : 0.5 - 1.25 negative
Caster Degrees - Front : 3.5 - 4.5 positive
Toe In (Minutes) - Front and Rear : 10 - 20
Ride height (Meausured from Outrigger corners to ground)
Front 125mm
Rear 130mm
Please Update by copying the following line, pasting at the bottom of the list, and substituting the correct values...
Description | nn |
====================
Description | lb/ft |
---|---|
Anti Roll bar Rear | ? |
Anti Roll bar Front | ? |
Bellhousing to Gearbox | 50 |
Bellhousing to engine | 50 |
Brakes: Caliper mount to hub carrier | 40-45 |
Brakes: Caliper to Caliper mount | 40-45 |
Brakes: Caliper to carrier | 40-45 |
Brakes: line banjo bolt | 9-10 + 90 degrees |
Cam/Rocker Covers | 15 |
Clutch cover to flywheel | 25 |
Diff front bracket to chassis | 95 |
Drag link to chassis | 40-45 |
Drag Link to suspension arm | 45-50 |
Front hub centre bolt | 70-75 |
Hub to hub carrier | 45-50 + loctite |
Lambda sensors | finger tight + 180 degrees |
Lower ball joint taper nut | 60-70 |
Lower ball joint to suspension | 20-25 |
Rear Hub - Driveshaft/Hub 41mm nut (*1) | 220 |
Shock Absorbers | 45-50 |
Slave cylinder to bellhousing | 15 |
Steering arm to hub carrier | 45-50 |
Track rod end taper nut | 35-40 |
Upper ball joint plate to hub carrier | 20-25 |
Upper ball joint to plate | 50-55 |
Wheel nut | 55-60 |
Wishbones Lower | 55 |
Wishbones Upper | 40-45 |
Propshaft to Diff flange bolts | 45 |
(*1) Thread tightening direction is in the direction of Wheel Rotation
Tracking and Camber Settings
Camber Degrees - Front and Rear : 0.5 - 1.25 negative
Caster Degrees - Front : 3.5 - 4.5 positive
Toe In (Minutes) - Front and Rear : 10 - 20
Ride height (Meausured from Outrigger corners to ground)
Front 125mm
Rear 130mm