RC car pulling away problem + hot start problem
Discussion
i have a losi nitro truck and have a couple of problems
its fitted with a roto start with a battery pack to start it
firstly it always starts from cold which is good i have a big problem pulling away from a standstill very very easy to stall it id say a 1/4 throttle problem is there anything i can do to help this ?
also when ive emptied a tank or if it stalls when warm it is very very very hard to start ive read on here about the one way bearing is it really easy to change or clean out is it a case of removing the exhaust and manifold then take the cover off ?
is it possable to fit a pull string with the roto start so cold start i can use the rotor and hot the pull string ? or is it just worth fitting a pull string and binning the roto stuff.
cheers in advance for any help or advise
regards
its fitted with a roto start with a battery pack to start it
firstly it always starts from cold which is good i have a big problem pulling away from a standstill very very easy to stall it id say a 1/4 throttle problem is there anything i can do to help this ?
also when ive emptied a tank or if it stalls when warm it is very very very hard to start ive read on here about the one way bearing is it really easy to change or clean out is it a case of removing the exhaust and manifold then take the cover off ?
is it possable to fit a pull string with the roto start so cold start i can use the rotor and hot the pull string ? or is it just worth fitting a pull string and binning the roto stuff.
cheers in advance for any help or advise
regards
Gassing Station | Scale Models | Top of Page | What's New | My Stuff