Do newer cars automatically raise RPM when realising clutch

Do newer cars automatically raise RPM when realising clutch

Author
Discussion

lewisp8

Original Poster:

9 posts

62 months

Friday 10th July 2020
quotequote all
Do modern (2016+) newer cars automatically increase rpm when pulling away?

I was driving a friend's Peugeot 308 diesel and noticed as I was releasing the clutch the revs would increase slightly on their own. I naturally set the RPM to 1100-1200rpm when setting off in my car but found in his car I would end up revving up a bit too much because the car was already doing it! On a steep hill in traffic you could crawl forward just on the clutch without touching the accelerator. In my car it would stall instantly 😂

Ambleton

7,065 posts

207 months

Friday 10th July 2020
quotequote all
yes

MrGTI6

3,252 posts

145 months

Friday 10th July 2020
quotequote all
Yes, worst ones for it are late diesel Fords. It frustrates me as it will accelerate clutch wear over time. Diesels are more than capable of pulling away on tick-over - even on steep inclines - so it seems completely unnecessary.

Jazoli

9,335 posts

265 months

Friday 10th July 2020
quotequote all
MrGTI6 said:
Yes, worst ones for it are late diesel Fords. It frustrates me as it will accelerate clutch wear over time. Diesels are more than capable of pulling away on tick-over - even on steep inclines - so it seems completely unnecessary.
It's not completely unnecessary, they raise the revs to protect the DMF, MK3 mondeos were terrible for it, after coming from the 1.8TD in the MK2 that you could drive away without touching the accelerator the MK3 2.0tdci's would just stall for fun, the ecu would not allow the revs to dip below a certain level and would stall the engine so it didn't shake the DMF to bits, it was really annoying until you got used to it eventually.

GroundEffect

13,864 posts

171 months

Friday 10th July 2020
quotequote all
MrGTI6 said:
Yes, worst ones for it are late diesel Fords. It frustrates me as it will accelerate clutch wear over time. Diesels are more than capable of pulling away on tick-over - even on steep inclines - so it seems completely unnecessary.
Seriously? The impact is absolutely tiny. Unless you want to launch every time at 0.1m/s2.

OP - it's called Feed Forward Launch. A general Quality of Life improvement for customers. Works well.

Turn7

24,704 posts

236 months

Friday 10th July 2020
quotequote all
My work van -Renault -sits with about 1800 rpm, clutch in and in gear, really irritating at traffic lights etc.

anonymous-user

69 months

Friday 10th July 2020
quotequote all
FIL’s Mondeo does, do find it quite handy for parking and such I must say.

Wife’s Pug 3008, interestingly, does not. Though it is a petrol.

PGN

217 posts

229 months

Saturday 11th July 2020
quotequote all
I didn't know about this. Another "improvement" that takes away control and designed to allow those who can't drive properly to make less of a mess of it while preventing those who can from doing it properly. My pet hate is cluch delay valve - hateful!

myvision

2,053 posts

151 months

Saturday 11th July 2020
quotequote all
Turn7 said:
My work van -Renault -sits with about 1800 rpm, clutch in and in gear, really irritating at traffic lights etc.
1800?

journeymanpro

860 posts

92 months

Saturday 11th July 2020
quotequote all
Turn7 said:
My work van -Renault -sits with about 1800 rpm, clutch in and in gear, really irritating at traffic lights etc.
Well you have other problems not related to the op.

Limpet

6,596 posts

176 months

Saturday 11th July 2020
quotequote all
Our old diesel Mini Clubman used to do it (and rev match on downshifts).

It's all to do with protecting the DMF apparently. Too few revs = excessive vibration = more wear and stress on the DMF.

gazza285

10,504 posts

223 months

Saturday 11th July 2020
quotequote all
It probably helps the DPF on diesels as well.

joropug

2,815 posts

204 months

Saturday 11th July 2020
quotequote all
Wife's A1 diesel does it and results in the car accelerating around tight corners in residential areas, really annoying !

DoubleD

22,154 posts

123 months

Saturday 11th July 2020
quotequote all
PGN said:
designed to allow those who can't drive properly to make less of a mess of it
Yep I agree, a good feature.

Cliftonite

8,576 posts

153 months

Saturday 11th July 2020
quotequote all
Turn7 said:
My work van -Renault -sits with about 1800 rpm, clutch in and in gear, really irritating at traffic lights etc.
You could try not having the clutch in and in gear at traffic lights. Drive properly and the vehicle may behave better. It, or at least important bits of it, will certainly last longer!



Don Roque

18,099 posts

174 months

Saturday 11th July 2020
quotequote all
gazza285 said:
It probably helps the DPF on diesels as well.
How did you come to that conclusion?

jamei303

3,041 posts

171 months

Saturday 11th July 2020
quotequote all
Torque converter autos won't give you this problem. Is it really worth the clutch and DMF worries just to be able to wiggle a stick on a diesel barge?

Krikkit

27,418 posts

196 months

Saturday 11th July 2020
quotequote all
PGN said:
I didn't know about this. Another "improvement" that takes away control and designed to allow those who can't drive properly to make less of a mess of it while preventing those who can from doing it properly. My pet hate is cluch delay valve - hateful!
Have you taken the synchros out of your gearbox too? Presumably you want a manual choke, carb, points etc for a petrol engine.

Brainpox

4,162 posts

166 months

Saturday 11th July 2020
quotequote all
My 2013 Mini GP2 did

Cold

16,012 posts

105 months

Saturday 11th July 2020
quotequote all
Cliftonite said:
Turn7 said:
My work van -Renault -sits with about 1800 rpm, clutch in and in gear, really irritating at traffic lights etc.
You could try not having the clutch in and in gear at traffic lights. Drive properly and the vehicle may behave better. It, or at least important bits of it, will certainly last longer!
But then it would roll backwards while waiting on hills.