This place is like heaven on earth
Discussion
caduceus said:
Definitely going to get some magic gel. my outside lights have shorted again
Also thinking about relocating my battery to the boot, so will need cable and ends.
Good find Pen.
There was a video on youtube showing someone using a ball from a ball bearing and a vice to crimp battery cable eyelet terminalsAlso thinking about relocating my battery to the boot, so will need cable and ends.
Good find Pen.
Will post it here if I find it
Anyway, a ball from a ball bearing could be taped onto the terminal, cable inserted into the terminal, placed in vice and ball squeezed into the terminal for crimping
PH member SturdyHSV https://www.pistonheads.com/gassing/topic.asp?h=0&... found out about the magic gel
Like yourself. I must order some for next time an underground mains cable joint trips its breaker
SPAL Radiator Fans https://www.a1electric.com/spal/faninfo.htm
Edited by Penelope Stopit on Sunday 13th June 10:52
Electric Turbo = Heaven
2 to 4 minutes boost, allow time for power pack recharge and boost again, easy to fit and wire
Proof of it working is in the YT videos
View Torqamp Video Channel https://www.youtube.com/c/TorqAmp/videos
These following videos are good fun, the first video shows the use of two electric turbos
2 to 4 minutes boost, allow time for power pack recharge and boost again, easy to fit and wire
Proof of it working is in the YT videos
View Torqamp Video Channel https://www.youtube.com/c/TorqAmp/videos
These following videos are good fun, the first video shows the use of two electric turbos
Have never crimped battery terminals, always use the screw type, I grab the cable with the screws and then use a blow torch to heat up and solder, fully filled with solder, takes practice though and the insulation does melt a little
These may be of some use to you https://www.12voltplanet.co.uk/battery-terminal-cl...
Cheers
These may be of some use to you https://www.12voltplanet.co.uk/battery-terminal-cl...
Cheers
PH Member DuncanM has found lots of ignition coils including ones for AJP8 Cerbera
NGK link
https://www.diycarserviceparts.co.uk/ngk-u2009-480...
https://www.gsparkplug.com/1x-ngk-ignition-coil-u2...
Lots here
https://www.diycarserviceparts.co.uk/electrical-li...
NGK link
https://www.diycarserviceparts.co.uk/ngk-u2009-480...
https://www.gsparkplug.com/1x-ngk-ignition-coil-u2...
Lots here
https://www.diycarserviceparts.co.uk/electrical-li...
Gassing Station | General TVR Stuff & Gossip | Top of Page | What's New | My Stuff