Another fibre glass type question
Discussion
I need to 'round off' a rather sharp body line in my fibreglass wing, and I am unsure about the method to use.
My initial idea was to grind off the sharp corner and lay matting & resin back to the inside of the shell, overlapping onto the old edges by about 50mm and making it more curvy, then finishing off with P38 filler on the outside face.
Is this right? Will it be strong enough?
Any advice would be appreciated - I'm a fibreglass virgin :D
My initial idea was to grind off the sharp corner and lay matting & resin back to the inside of the shell, overlapping onto the old edges by about 50mm and making it more curvy, then finishing off with P38 filler on the outside face.
Is this right? Will it be strong enough?
Any advice would be appreciated - I'm a fibreglass virgin :D
Gassing Station | Bodywork & Detailing | Top of Page | What's New | My Stuff