Ford Sierra 1.6 Laser | Spotted
Thought it was only six-figure Sierras left on PH?
No, this Sierra is not some crazy Cosworth, or even an XR4x4 for that matter, but I thought something comparatively (though perhaps not objectively) cheap and cheerful was no bad thing for a change. And they don't come much cheaper and cheerier than a 1986 Ford Sierra Laser with a good-old 1.6-litre 'Pinto' under the bonnet. If ever there was an antidote to "it's all too complicated these days; you need to plug a compooter to do anything' then surely this is it?
This is an engine, after all, that every garage at the back of every side street in every town should have no problem fixing, using nothing more byzantine than a dwell meter, a selection of feeler gauges and, possibly, a short sharp tap with a soft-faced mallet.
And there shouldn't be any difficulty in getting hold of parts, either. After just a quick breeze through the Google entry for 'Pinto parts' I can tell you that head gasket kits are yours from a little over £20, a water pump is £30, a dizzy comes in at under £70 and a clutch kit is £80. If you're currently restoring a DB5, or some such exotic, and your brain has stopped observing numbers that small, there really is no error or need to add any more zeros.
Not that you will hopefully need to do too much too soon to keep this particular Sierra on the road. It's covered just 48,000 miles, although it's showing 76,000km on account of it being a left-hooker imported from Belgium - where it may well have been born, bearing in mind Sierras were made in Genk. And it comes with what's described as a full service history and some of those lovely little details like two keys complete with the supplying dealer's fob.
The Sierra was really the last bastion of simplicity in terms of its layout, too. A longitudinal engine driving the rear wheels via, in this case, a four-speed manual gearbox. And while I may have written not so long ago about how the Peugeot 405 monstered the Sierra when it came to handling, refinement, ride and, well, pretty much everything else, time is a leveller, as they say, and in 2021 does any of that still matter?
I don't think so. It's just lovely to see a nicely preserved piece of history that brings back sweet memories of the mid-eighties, when life was simpler without emails and iPhones, and Kim Wilde was in her pomp. It's just a feel-good thing. Well, it was for me.
SPECIFICATION | FORD SIERRA 1.6 LASER
Engine: 1,593cc, 4-cylinder, naturally aspirated
Transmission: 4-speed manual, rear-wheel drive
Power (hp): 75
Torque (lb ft): 87
CO2: N/A
MPG: N/A
Recorded mileage: 48,000
Year registered: 1986
Price new: N/A
Yours for: £3,995
I had a mate at work who only used to buy ones made in one of the locations (can’t remember which tbh) as they seemed to be built better and resisted the onset of ferrous oxide better (he was an engineer before becoming a cop so o bow to his greater knowledge…)
It did look the part but underneath there were still a lot of anything but revolutionary Cortina bits. Sierras felt heavy and drove like boats compared to just about all their rivals. Reasonably comfy and practical though.
This one does look to be in remarkable fettle.
Now that I think about it.l, it's amazing Ford are still in business, given the crap they've punted (or should that be pinted) over the years...
Dad had a few cars with them including an RS2000, an A60 Austin Cambridge with a 2.1 stock car engine, a handful of Sierras (I personally think the CVH is crap) and at one point this bizarre kit car that left the factory with a 1.6 Turbo Technics Pinto.
They are a piece of piss to work on and there's that much out there tuning wise for all of the capacities and variations due to their popularity in stock car formulae and kit car usage.
I still think they're the ideal 'first car' engine for someone that is interested in getting their hands dirty.
I drove it when I passed my test, it had the same 1.6 Pinto and was woefully slow, with a terrible gearbox throw and hefty non power assisted steering.
It ended up being sat under a cover in the garage for ten years when he went though a selection of Fords - A 2 litre Mondeo (Very good), a mk 4 Fiesta ST which was decent, and now he has a Mk 6 Fiesta ST, which i'm hoping to have off him when he comes to sell.
My mom told him the Sierra had to go, he expected to get around £800 for it - It ended up selling for over 5k on ebay. (It was in immaculate condition, albeit over 100,000 miles under it's wheels).
Of course there were better options available but many Brits were still preoccupied with not buying foreign stuff, and Ford was always viewed as British (the irony...).
Ford was particularly talented at making cars just good enough for the market, but no better than they had to be (the Scandinavians have a word for it: Lagom - "just right enough"). The body was a revelation - the chassis was not. Over time the engines got better (well, once they realised the CVH was crap) and by the time the run-out models were on sale they were actually quite good, but woefully dated. My dad had a K-reg 2.0 GT with the twin-cam engine: it was quite an engaging drive, and he bought it because he wanted a new car but wanted RWD, so left it as late as possible to order before the books closed.
He had a string of these through the mid 80’s to early 90’s
As a young boy I would always have my head buried in a car
Brochure and we would always have fun correcting the salesmen
On their car specs !
I can tell you that a U.K spec Laser had a sunroof, rear wiper
And 5 speed box, so this truly is poverty spec at its peak !
He briefly attempted to move on to a Mondeo 1.8 but hated the engine so immediately sold it on, kept the Sierra until it died and has had Mercs ever since.
Gassing Station | General Gassing | Top of Page | What's New | My Stuff