MG Midget...V8 in disguise..Super Sprite
Discussion
This car has been through several iterations and started like this... |https://thumbsnap.com/98aC9sFW[/url]
then it raced as this...
|https://thumbsnap.com/sPTYNT0u[/url]
After it became a Tube chassied Competion Altered.
|https://thumbsnap.com/ne7Ax9Uw[/url]
Then I bought this 1500 Midget, it was a bit bent...
.|https://thumbsnap.com/3TtdoPTU[/url]
It was straightened and my old Sprite body panels used, together with a roll cage and Rover V8 engine. Several resprays later...
Here it is just before it went back into my garage. The hood is only placed in position.
[url][url][url][url]
then it raced as this...
|https://thumbsnap.com/sPTYNT0u[/url]
After it became a Tube chassied Competion Altered.
|https://thumbsnap.com/ne7Ax9Uw[/url]
Then I bought this 1500 Midget, it was a bit bent...
.|https://thumbsnap.com/3TtdoPTU[/url]
It was straightened and my old Sprite body panels used, together with a roll cage and Rover V8 engine. Several resprays later...
Here it is just before it went back into my garage. The hood is only placed in position.
[url][url][url][url]
Edited by Flying Phil on Thursday 8th October 09:44
Whilst the V8 Sprite was out in the sun I finally finished part of my rewiring and ran the front wiring loom up through the chassis leg that supported the "Rubber Bumper" in its previous life.
Needless to say it was a "faff" getting the five wires for the ignition module and coil out of one hole and the lighting circuit out of the other hole. However after three tries it was completed....now to get the connections done!
Gratuitous picture of 8 ram pipes on Quad Webers!
Needless to say it was a "faff" getting the five wires for the ignition module and coil out of one hole and the lighting circuit out of the other hole. However after three tries it was completed....now to get the connections done!
Gratuitous picture of 8 ram pipes on Quad Webers!
Gassing Station | MG | Top of Page | What's New | My Stuff