Salisbury Diff Pinion Seal Installation
Discussion
I recently replaced the pinion seal in my 350 and it almost immediately leaked again. I have removed it and it would seem the oil was leaking not from the rubber seal, but around the outer edger of the seal where it is pressed into the diff housing! It had been installed correctly so I am not sure why this hsould be possible. I plan to replace it with a new seal and install it with a layer of gasket sealer such as red hermatite.
Is this a common problem as I have never needed to fit a seal in this way before?
Is this a common problem as I have never needed to fit a seal in this way before?
Gassing Station | Wedges | Top of Page | What's New | My Stuff