Tuscan SP6 rebuild time
Discussion
Hi
I will be rebuilding my speed 6 early next year, I did research what the weak points are a few years back and just wanted to check I have remembered all the issues!
Finger follower and valves
Oil feed modification ( inlet finger follower shaft mod to take oil from the back end of the engine to the exhaust finger follower shaft)
Half time bearings
Is the RG simplex xonversion worth doing?
Im going to check the bearings on the bottom end and fit some total seal piston rings. As far as I remember the bottom end is fine on standard BHP but anything uprated and the rods need to go is that correct?
Thank you, and sorry I am sure this is covered many times on this thread, please send a link to save answering twice!
Regards
lee
I will be rebuilding my speed 6 early next year, I did research what the weak points are a few years back and just wanted to check I have remembered all the issues!
Finger follower and valves
Oil feed modification ( inlet finger follower shaft mod to take oil from the back end of the engine to the exhaust finger follower shaft)
Half time bearings
Is the RG simplex xonversion worth doing?
Im going to check the bearings on the bottom end and fit some total seal piston rings. As far as I remember the bottom end is fine on standard BHP but anything uprated and the rods need to go is that correct?
Thank you, and sorry I am sure this is covered many times on this thread, please send a link to save answering twice!
Regards
lee
Gassing Station | Speed Six Engine | Top of Page | What's New | My Stuff